The short version of deamidation fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-04 and is reviewed periodically as new material appears.
Peptides are short chains of amino acids linked by amide bonds, and their storage stability depends on sequence, length, and three-dimensional structure. Chemical degradation can occur through hydrolysis, oxidation, deamidation, and aggregation, while physical changes such as precipitation or surface adsorption reduce recovery. Storage conditions are chosen to slow these processes without altering the peptide itself. Because peptides vary widely, no single condition suits every sequence, so laboratories often establish stability empirically for each batch.
Temperature is a primary factor because most degradation reactions proceed more slowly at lower temperatures. Lyophilized peptides are commonly held at -20 °C or below, although some sequences remain stable at 2–8 °C for limited periods. Moisture uptake during handling can accelerate hydrolysis, so sealed containers and desiccants are used. Solutions are generally less stable than powders and may require freezing at -80 °C or refrigeration, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation even when the storage temperature is otherwise suitable.
Light, oxygen, and pH influence peptide integrity through specific side-chain reactions. Methionine and cysteine residues are susceptible to oxidation, and tryptophan can degrade under strong light. Inert gas overlays and amber glass or opaque containers reduce these risks. pH affects charge, solubility, and the rate of deamidation or aggregation; a value that minimizes one pathway may increase another. The optimal pH and buffer for a given peptide are often determined experimentally, and open questions remain about predicting stability from sequence alone.
Peptides are short chains of amino acids that can undergo both chemical and physical degradation. Chemical pathways include hydrolysis of peptide bonds, oxidation of methionine or cysteine residues, deamidation of asparagine or glutamine, and isomerization of aspartate. Physical instability leads to aggregation, precipitation, or adsorption to surfaces. The rate of these processes depends on the peptide sequence, the formulation, and the storage environment. Because each peptide has a unique composition, no single storage condition applies to all peptides. Stability studies are therefore conducted to define suitable conditions for each specific molecule.
Temperature is a primary factor in peptide storage. Lower temperatures reduce molecular motion and slow degradation reactions, but freezing can concentrate solutes and promote aggregation. Lyophilized powders are commonly held at -20°C, whereas solutions are often kept at -80°C. Repeated freeze-thaw cycles are harmful because ice crystal formation and pH shifts can damage the peptide. The glass transition temperature of a lyophilized cake influences its stability; below this temperature, molecular mobility is restricted. For solutions, the choice between -20°C and -80°C depends on the peptide's sensitivity and the intended storage duration.
Moisture, oxygen, and light also affect peptide integrity. Lyophilized powders absorb water from the air, which can enable hydrolysis and conformational changes. Oxygen promotes oxidation of sensitive residues, so storage under inert gas or in sealed vials is common. Light exposure can cause photodegradation, particularly for peptides containing aromatic amino acids. Buffer choice and pH influence charge state and solubility; extremes of pH accelerate deamidation and hydrolysis. Adding stabilizers such as sugars or polyols can protect the peptide during freezing and drying. Optimal conditions are determined empirically for each peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance (lyophilized) | White to off-white powder | May appear fluffy, crystalline, or amorphous depending on manufacturing |
| Solubility class | Typically water-soluble | Solubility varies with sequence and pH; some require organic co-solvents |
| Typical storage temperature (lyophilized) | -20 °C or lower | Some peptides tolerate 2–8 °C; moisture control is critical |
| Typical storage temperature (solution) | -80 °C to 2–8 °C | Depends on peptide; avoid repeated freeze-thaw cycles |
| Common analytical method | Reverse-phase HPLC | Used for purity, identity, and degradation monitoring; mass spectrometry often confirms mass |
When a peptide arrives, the vial should be inspected for damage, and its label, lot number, and accompanying analytical data should be recorded. Cold vials should equilibrate to room temperature before opening to prevent condensation on the powder. Moisture uptake can reduce stability and complicate accurate weighing or reconstitution. Inventory systems that track date, quantity, and storage location help prevent unnecessary temperature cycling. Personnel should follow institutional or manufacturer instructions for any specific peptide.
Reconstitution is often performed with sterile water, buffer, or a water-miscible organic solvent, depending on solubility. The solvent should be added gently along the vial wall, and the solution mixed by gentle swirling rather than vigorous vortexing, which can cause foaming and surface denaturation. Some sequences require a small amount of base or acid to dissolve, followed by pH adjustment. Preparing a concentrated stock solution can simplify later dilution, but the stock itself may have limited stability. Records of solvent, concentration, and date support reproducibility.
Peptides are short chains of amino acids linked by amide bonds. Their stability depends on sequence, length, and the chemical environment. Common degradation routes include hydrolysis of the peptide backbone, oxidation of methionine or cysteine residues, deamidation of asparagine or glutamine, and aggregation through hydrophobic or electrostatic interactions. These processes can alter mass, charge, or biological activity, so storage conditions aim to slow them. The relative importance of each route varies widely among peptides.
Water is a central factor in peptide degradation because it enables hydrolysis and mobilizes reactive species. Lyophilized or dry powders typically remain stable for longer than solutions when kept cool and dry. Oxygen can drive oxidation, particularly for sulfur-containing residues, while light can catalyze side-chain damage. Buffer choice and pH influence charge state and can accelerate or slow deamidation and aggregation. Freeze-thaw cycles may concentrate solutes or promote ice-induced aggregation, so minimizing such cycles is a common handling goal.
The first symptom of CJD is usually rapidly progressive dementia, leading to memory loss, personality changes, and hallucinations. Myoclonus (jerky movements) typically occurs in 90% of cases, but may be absent at initial onset. Other frequently occurring features include anxiety, depression, paranoia, obsessive-compulsive symptoms, and psychosis. This is accompanied by physical problems such as speech impairment, balance and coordination dysfunction (ataxia), changes in gait, and rigid posture. In most people with CJD, these symptoms are accompanied by involuntary movements. Rarely, unusual symptoms like the alien limb phenomenon have been observed. The duration of the disease varies greatly, but sporadic (non-inherited) CJD can be fatal within months or even weeks. Most affected people die six months after initial symptoms appear, often of pneumonia due to impaired coughing reflexes. About 15% of people with CJD survive for two or more years. The symptoms of CJD are caused by the progressive death of the brain's nerve cells, which are associated with the build-up of abnormal prion proteins forming in the brain. When brain tissue from a person with CJD is examined under a microscope, many tiny holes can be seen where the nerve cells have died. Parts of the brain may resemble a sponge where the prions were infecting the areas of the brain.
Two species of AAV were recognised by the International Committee on Taxonomy of Viruses in 2013: adeno-associated dependoparvovirus A (formerly AAV-1, −2, −3 and −4) and adeno-associated dependoparvovirus B (formerly AAV-5). Until the 1990s, virtually all AAV biology was studied using AAV serotype 2. However, AAV is highly prevalent in humans and other primates and several serotypes have been isolated from various tissue samples. Serotypes 2, 3, 5, and 6 were discovered in human cells, AAV serotypes 1, 4, and 7–11 in nonhuman primate samples. As of 2006 there have been 11 AAV serotypes described, the 11th in 2004. AAV capsid proteins contain 12 hypervariable surface regions, with most variability occurring in the threefold proximal peaks, but the parvovirus genome in general presents highly conserved replication and structural genes across serotypes. All of the known serotypes can infect cells from multiple diverse tissue types.
Division of analytical chemistry and laboratory of bio-electrochemical biosensor research function in this department. The division conducts research in the area of methods of electrochemical analysis using chemically modified electrodes and biosensors. The head of the department is Professor Gennady A. Evtyugin, doctor of Science in chemistry. The Department conducts research in the following fields:
Sources: en.wikipedia.org
Bruce Randall Donald (born 1958) is an American computer scientist and computational biologist. He is the James B. Duke Professor of Computer Science and Biochemistry at Duke University. He has made numerous contributions to several fields in Computer Science such as robotics, Microelectromechanical Systems (MEMS), Geometric & physical algorithms and computational geometry, as well as in areas of Structural Molecular Biology & Biochemistry such as Protein design, Protein Structure Determination and Computational Chemistry.
Secretases are enzymes that "snip" pieces off a longer protein that is embedded in the cell membrane. Among other roles in the cell, secretases act on the amyloid-beta precursor protein (APP) to cleave the protein into three fragments. Sequential cleavage by beta-secretase 1 (BACE) and gamma-secretase (γ-secretase) produces the amyloid-beta peptide fragment that aggregates into clumps called amyloid plaques in the brains affected by Alzheimer's disease. If alpha-secretase (α-secretase) acts on APP first instead of BACE, no amyloid beta is formed because α-secretase recognizes a target protein sequence closer to the cell surface than BACE. The non-pathogenic middle fragment formed by an α/γ cleavage sequence is called P3. The structure of the three secretases varies widely.
An organic compound is a chemical whose molecules contain carbon. Carbon is abundant in the Sun, stars, comets, and in the atmospheres of most planets of the Solar System. Organic compounds are relatively common in space, formed by "factories of complex molecular synthesis" which occur in molecular clouds and circumstellar envelopes, and chemically evolve after reactions are initiated mostly by ionizing radiation. Purine and pyrimidine nucleobases including guanine, adenine, cytosine, uracil, and thymine, as well as sugars, have been found in meteorites. These could have provided the materials for DNA and RNA to form on the early Earth. The amino acid glycine was found in material ejected from comet Wild 2; it had earlier been detected in meteorites. Comets are encrusted with dark material, thought to be a tar-like organic substance formed from simple carbon compounds under ionizing radiation. A rain of material from comets could have brought such complex organic molecules to Earth. During the Late Heavy Bombardment, meteorites may have delivered up to five million tons of organic prebiotic elements to Earth per year. Currently 40,000 tons of cosmic dust falls to Earth each year.
Sources: en.wikipedia.org
Vasoactive intestinal peptide (VIP) is a 28-residue amino acid peptide first characterized in 1970 that was initially isolated from porcine duodenum. A member of the secretin/glucagon hormone superfamily, VIP was initially discovered owing to its potent vasodilatory effects (as its name implies). VIP is widely distributed in the central and peripheral nervous system as well as in the digestive, respiratory, reproductive, and cardiovascular systems as a neurotransmitter and neuroendocrine releasing factor. These effects contribute to an extensive range of physiological and pathological processes related to development, growth, and the control of neuronal, epithelial, and endocrine cell function. VIP acts on two receptors - VPAC1 and VPAC2, which are class B of G-protein-coupled receptors (GPCRs).VPAC1 is mainly present in the lung and T-lymphocytes, whereas VPAC2 is mainly seen in the smooth muscle, mast cells and the basal parts of the lung mucosa.
In 1961, Peter Mitchell proposed chemiosmosis as a cell's primary system of energy conversion. The mechanism, now ubiquitous in living cells, powers energy conversion in micro-organisms and in the mitochondria of eukaryotes, making it a likely candidate for early life. Mitochondria produce adenosine triphosphate (ATP), the energy currency of the cell used to drive cellular processes such as chemical syntheses. The mechanism of ATP synthesis involves a closed membrane in which the ATP synthase enzyme is embedded. The energy required to release strongly bound ATP has its origin in protons that move across the membrane. In modern cells, those proton movements are caused by the pumping of ions across the membrane, maintaining an electrochemical gradient. In the first organisms, the gradient could have been provided by the difference in chemical composition between the flow from a hydrothermal vent and the surrounding seawater, or perhaps meteoric quinones that were conducive to the development of chemiosmotic energy across lipid membranes if at a terrestrial origin.
Topical nonsteroidal anti-inflammatory drugs provide pain relief in common conditions such as muscle sprains and overuse injuries. Since the side effects are also lesser, topical preparations could be preferred over oral medications in these conditions. Some novel and investigational analgesics include subtype-selective voltage-gated sodium channel blockers such as funapide and raxatrigine, as well as multimodal agents such as ralfinamide. Audioanalgesia Electroanalgesia Pain management Patient-controlled analgesia Pain in babies Congenital analgesia (insensitivity to pain)
Sources: en.wikipedia.org
Removing water reduces hydrolytic and some oxidative degradation. Powder forms are generally more stable for long-term storage than solutions. Stability still depends on peptide sequence, residual moisture, and container conditions.
Freezing slows most chemical reactions, but it can also concentrate solutes and promote aggregation during freezing or thawing. Repeated freeze-thaw cycles are often more damaging than constant cold storage. Some peptides require specific buffers or additives to remain soluble.
pH affects charge, solubility, and the reactivity of amino acid side chains. It can influence deamidation, oxidation, and aggregation pathways. The best pH is peptide-specific and is usually identified through stability testing.
Removing water reduces hydrolytic degradation and limits microbial growth. Lyophilized powders are generally more stable at higher temperatures than aqueous solutions. They also tolerate shipping with less risk of degradation.